Porter Monitor&reg; 14 Series Tub & Shower Trim

Topics: Performance

Age: 35 to 44

Gender: Female

Project Type: New

Ownership: < 1 year

Skill Level: Intermediate

2 weeks, 6 days ago

by

Debbie

Hambden, OH, USA

0points

0out of 0found this question helpful.

Was this helpful?helpful0unhelpful0

2I have this question too

Answer:

Thank you for your question. Delta Faucet model # 144984-OB-A contains a rotational limit stop that may need adjusting to allow more hot water to flow through the valve. Included here are the instructions to adjust the rotational limit stop. The directions are on page 7.

http://www.deltafaucet.com/customer...

Skill Level: Advanced

2 weeks, 4 days ago

by

0points

0out of 0found this answer helpful.

Was this helpful?helpful0unhelpful0

Has staff answer

Has expert answer

Porter Monitor® 14 Series Tub & Shower Trim

1 answer

I just purchased and installed the Celice 3 piece shower/bath component. Though I love the look I am very disapointed that I cannot control the volum

by

DC

Montana, USA

Apparently I have very good water pressure and the pressure is much too high. I run out of hot water before I ever finish my shower. Is there a replacement that goes with this set that I can change out to control the volume of water coming out of the shower head and spout? the middle piece that controls the on and off I guess is what I would need.

I know I can chnage the shower head but that doesn't sole the issue when I run bathwater.

Topics: Purchase, Features, Performance

Age: 45 to 54

Gender: Female

Project Type: New

Ownership: < 1 year

Skill Level: Intermediate

2 months ago

by

DC

Montana, USA

0points

0out of 0found this question helpful.

Was this helpful?helpful0unhelpful0

Answers

Staff
Expert

Answer:

Thank you for your question. The Celice series is only available for tub/shower combination in the 1400 series. The 1400 series only has temperature control on the handle. If you would like to control the volume too, you will need to switch out your trim for a 1700 series model in another style.

Skill Level: Advanced

1 month, 3 weeks ago

by

0points

0out of 0found this answer helpful.

Was this helpful?helpful0unhelpful0

Has staff answer

Has expert answer

Porter Monitor® 14 Series Tub & Shower Trim

1 answer

How does the handle correctly install?

by

BethIL

I had this installed professionally, and I feel the handle has never been correctly installed. It never feels as though it is solidly seated and all attempts to get it that way fail. After a few uses, it needs to be re-installed, because it comes loose. VERY frustrating, to say the least. The best solution we've found, which is less than ideal, is to take the disc off that enables the scald control. As I said, less than ideal because we have a child. And because it still isn't right, just better. We feel as though the slot for the stem to slide into on the handle is too large, perhaps, on our faucet.

Topics: Warranty, Assembly

Age: 35 to 44

Gender: Female

Project Type: New

Ownership: < 1 year

Skill Level: Beginner

5 months ago

by

BethIL

-1point

0out of 1found this question helpful.

Was this helpful?helpful0unhelpful1

Answers

Staff
Expert

Answer:

Thank you for your question. I apologize for the issue that you are experiencing. To ensure the proper part is identified for repair, please contact our toll-free Home Owner/Warranty department at 800-345-3358.

Skill Level: Advanced

4 months, 4 weeks ago

by

0points

0out of 0found this answer helpful.

Was this helpful?helpful0unhelpful0

Has staff answer

Has expert answer

Porter Monitor® 14 Series Tub & Shower Trim

1 answer

Compatible with other brands. I currently have a Moen Tub and Shower Trim.....will this series work or is it not compatible without having to do a ma

by

dalucca

Roseville, CA, USA

Topics: Assembly

Project Type: Replacement

3 months, 3 weeks ago

by

dalucca

Roseville, CA, USA

0points

0out of 0found this question helpful.

Was this helpful?helpful0unhelpful0

Answers

Staff
Expert

Answer:

Thank you for your question. Delta Faucet model # 144984-OB-A contains the valve assembly in the box for a complete faucet. It is not compatible with a Moen valve and the valve will need to be replaced with a Delta valve to be able to use this faucet.

Skill Level: Advanced

3 months, 3 weeks ago

by

0points

0out of 0found this answer helpful.

Was this helpful?helpful0unhelpful0

Has staff answer

Has expert answer

Porter Monitor® 14 Series Tub & Shower Trim

1 answer

Valve Body

by

Leon

Says it comes with complete multichoice valve body. What is the product number of valve it comes with? And will it accept the the cartridge RP46463 for the 1700 series

Topics: Features

Age: 35 to 44

Gender: Male

Project Type: New

Skill Level: Intermediate

4 months, 2 weeks ago

by

Leon

0points

0out of 0found this question helpful.

Was this helpful?helpful0unhelpful0

Answers

Staff
Expert

Answer:

Hi Leon! Thanks for your question. Porter Monitor® 14 Series Tub & Shower Trim (144984-OB-A) comes with the R10000-UNBX rough, and it will accept the RP46463. However, you will need to order new trim to fit that cartridge.

Skill Level: Advanced

4 months, 2 weeks ago

by

DeltaJess

Indianapolis, IN, USA

0points

0out of 0found this answer helpful.

Was this helpful?helpful0unhelpful0

Has staff answer

Has expert answer

Porter Monitor® 14 Series Tub & Shower Trim

1 answer

Will Monitor 14 Series Trim replace Monitor 1400 Series Trim?

by

Dean

Sarver, PA 16055, USA

I have an existing installed Tub & Shower Trim in chrome that has "Monitor" and "1400 Series" printed on it. Will the Monitor 14 Series Tub & Shower Trim work as a replacement? I want to switch from the existing chrome to Oil Rubbed Bronze.

Topics: Purchase

Age: 55 to 64

Gender: Male

Project Type: Replacement

Ownership: 6-10 years

Skill Level: Intermediate

5 months, 1 week ago

by

Dean

Sarver, PA 16055, USA

0points

0out of 0found this question helpful.

Was this helpful?helpful0unhelpful0

Answers

Staff
Expert

Answer:

Thank you for contacting Delta Faucet Company.

You need to first make sure your trim plate has the screws at the 1 and 7 o'clock position. If so, then any of our model trims that start with T13 or T14 will work to replace your trim.

Secondly, these new trims come with a cartridge. The cartridge will only fit the Multichoice rough. If your cartridge is not leaking, then do not replace it, it will be fine. If your cartridge is leaking, the new cartridge will replace it only if your cartridge has a gray colored cap (cap can be seen after removing the handle). If the color of your cap is white, then you would need to order RP19804.

5 months, 1 week ago

by

Delta

Indianapolis, IN, USA

0points

0out of 0found this answer helpful.

Was this helpful?helpful0unhelpful0

Has staff answer

Has expert answer

Porter Monitor® 14 Series Tub & Shower Trim

1 answer

faceplate on turnon valve

by

Drew

Gardnerville, NV, USA

There is one screw on the lower left and the second screw on the upper right of the faceplate. The screws need to match what valve is currently in or the tile has to be ripped out. Can I use this Delta product to replace what I have now which has the two screws on the lower left and lower right under where the water is turned on?

Topics: Purchase

Age: 55 to 64

Gender: Female

Project Type: Replacement

Ownership: < 1 year

Skill Level: Beginner

6 months ago

by

Drew

Gardnerville, NV, USA

0points

0out of 0found this question helpful.

Was this helpful?helpful0unhelpful0

Answers

Staff
Expert

Answer:

Thank you for your question. Based on your description and the placement of your screw holes, this trim will not work for you.

You may have a 600 series if you turn on your water by pushing up and then turning right or left. If this is the case, we do offer a rennovation kit in Chrome, Venetian Bronze, and Stainless Steel. The model number is RP54870.

Skill Level: Advanced

6 months ago

by

0points

0out of 0found this answer helpful.

Was this helpful?helpful0unhelpful0

Has staff answer

Has expert answer

Porter Monitor® 14 Series Tub & Shower Trim

1 answer

Can I use just the shower head and valve in the shower and then purchase another valve to use with the tub spout in a separate tub?

by

Jeremy

Topics: Performance

Project Type: Replacement

Ownership: < 1 year

Skill Level: Beginner

6 months ago

by

Jeremy

0points

0out of 0found this question helpful.

Was this helpful?helpful0unhelpful0

Answers

Staff
Expert

Answer:

Thank you for your question. Delta Faucet model number # 144984-OB-A can be broken up and used in different showers. However, you will need to plug the tub spout in the valve for the 144984-OB-A. You should be able to purchase a plug at your local wholesaler or retailer.

Skill Level: Advanced

6 months ago

by

0points

0out of 0found this answer helpful.

Was this helpful?helpful0unhelpful0

Has staff answer

Has expert answer

Porter Monitor® 14 Series Tub & Shower Trim

1 answer

How do I control the water pressure?

by

Newportoz

Newport Beach, CA, USA

When the valve is on cold the water pressure is very low but when I turn it to hot the pressure is very strong. Is there a way to adjust the pressure?

Topics: Performance

Age: 55 to 64

Gender: Male

Project Type: New

Ownership: < 1 year

Skill Level: Beginner

6 months ago

by

Newportoz

Newport Beach, CA, USA

0points

0out of 0found this question helpful.

Was this helpful?helpful0unhelpful0

Answers

Staff
Expert

Answer:

Thank you for your question. I apologize for the issue that you are experiencing. To ensure the proper part is identified for repair, please contact our toll-free Home Owner/Warranty department at 800-345-3358.

Skill Level: Advanced

6 months ago

by

-3points

1out of 5found this answer helpful.

Was this helpful?helpful1unhelpful4

Has staff answer

Has expert answer

Porter Monitor® 14 Series Tub & Shower Trim

1 answer

Water comes from shower head whether diverter is turned to shower or tub

by

Paul

Lafayette, IN

After installing the shower valve assembly and the subsequent bath/surround, paying close attention to all the drop specifications listed in the installation manual, we found that water comes from the shower head at all times. It comes out slow at first but eventually builds till it's equal with the water that comes from the diverter spout.

This is not the first time I've run into this problem with the tub/shower faucet that uses the delta multichoice 13/14 cartridge assembly. In the past I have taken the spout/diverter off exposing straight pipe and the problem goes away. I have not tried this as of yet.

How do I resolve this problem?

Topics: Performance

Age: 35 to 44

Gender: Male

Project Type: New

Ownership: < 1 year

Skill Level: Advanced

8 months ago

by

Paul

Lafayette, IN

0points

0out of 0found this question helpful.

Was this helpful?helpful0unhelpful0

2I have this question too

Answers

Staff
Expert

Answer:

Thank you for your question. I apologize for the issue that you are experiencing. To ensure the proper part is identified for repair, please contact our toll-free Home Owner/Warranty department at 800-345-3358.

Skill Level: Advanced

8 months ago

by

-1point

0out of 1found this answer helpful.

Was this helpful?helpful0unhelpful1