Single Handle Vessel Bathroom Faucet
Ara®
Model#: 767LF
767LF is rated
out of
5 by
1.
-
Water-Efficient
-
No-Lead Compliant
-
WaterSense® Labeled
- Laminar flow lends a beautiful, refined look that complements the design of the faucet
- Single hole installation
- Less pop-up
- ADA Compliant
- WaterSense labeled faucet uses at least 20% less water than the industry standard without compromising performance
- Standard spout
Special Features
-
ADA Compliant
Installation Information
Single hole installation
- Flow Rate: 1.20 gpm @ 60 psi, 4.5 L/min @ 414 kPa
- Spout Height: 13-3/8"
- Spout Length: 5-3/8"
- Fittings Type: 3/8" compression fittings
- Drain Type: Less pop-up
- Deck Thickness: 2.25"
- Valve Type: Ceramic valve
Rated 5 out of
5
by
JB2017 from
Replacement
I bought these faucets to replace a different brand I had installed just over 2 years ago.
These Delta faucets are great, a lot quieter than the previous brand and look really good.
What is also great about Delta is the lifetime warranty and ability to replace parts, which the previous brand did not have. Great product
Date published: 2018-01-13
The technical drawing shows a pop up drain but the description says "less pop up". Does this or does this not have an included pop up drain?
Hi TalkingFingers,
Thank you for your question. The Delta Ara Vessel Lavatory 767LF faucet does not come with a Pop-Up/Drain assembly.
Best regards,
Tanya
Date published: 2018-05-02
What is laminar flow? What is the "riser"?
Thank you for your question, Dale! The tall bottom part of the faucet body of the Delta Ara Vessel Lavatory 767LF faucet is considered the riser. It makes the faucet taller than normal lavatory faucets. This faucet has a "Laminar flow" in which the water travels smoothly or in regular paths, in contrast to turbulent flow, in which the water undergoes irregular fluctuations and mixing. This flow lends a beautiful, refined look that complements the design of the faucet.
Best regards,
Tanya
Date published: 2018-04-17
Supply lines
The spec shows staggered pex supply lines for this faucet. That is much more than needed for my application. Are the integrated supply lines designed to be able to trim them to the necessary length?
Hi Jake,
Thank you for your question. We recommend looping the PEX supply lines. However, you may cut the supplies shorter by following the directions on page 8 under Custom Fit Connections. Delta is not responsible for tubing that is cut too short or cut in a way that will not allow for a leak-free joint.
https://media.deltafaucet.com/MandI/83894%20Rev%20B.pdf
Regards,
Jon
Date published: 2017-09-28
What exact size hole is required in countertop??
What is the hole size so I can tell my countertop contractor??Delta Faucet Ara™ 1.5 gpm Single Lever Handle 1-Hole Lavatory Faucet with Riser in Stainless Steel
D767LFSS
Hi Sevan,
Thank you for your question. All measurements are available for model 767LF in the technical specifications under product support.
Best Regards,
Courtney
Date published: 2016-06-28
