How to refill the bottle
Can't simply pour soap into top... it just overflows. Do you make some easy way to handle this?
Thank you for your question. We do recommend filling your soap dispenser from the top to prevent bottle breakage from taking the bottle on and off. We do offer a funnel that may make it easier when filling your soap dispenser from the top. Delta Faucet model # RP30395 can be purchased at your local retailer or wholesaler.
Date published: 2016-04-18
Soap Dispenser Instructions RP50781 - does black gasket (part #4) go on top of sink or underneath?
Picture shows gasket above sink, but instructions state to put through hole in sink - which is correct?
Thank you for your question! The gasket should fit into the base of the dispenser and will sit on top of the sink.
Date published: 2016-04-18
Is there a replacement pump replacement that uses foaming soap?
I have a new Delta kitchen faucet that came with this soap dispenser and would like to replace just the pump portion so I could use foaming soap that foams when pumping into my hand.
Thank you for your question. The RP47888 is the only pump made for the Delta RP50781 Soap/Lotion Dispenser. Soap Dispensers can use liquid dish soap, liquid hand soap, alcohol based hand-sanitizer,and even typical hand lotions. We do not recommend foaming soaps, because Delta soap/lotion dispensers are not designed to release foam from them.
Date published: 2017-08-12
I need a replacement soap dispenser bottle for my faucet 4353-AR-DST. Is there a part number?
Also, the handle on mine does not look like the one in the parts list that is shown on this website. See photo.
Hi Tracy, Thank you for your question. The 4353-AR-DST was not offered with a soap dispenser. Only the (SS) brilliance stainless 4353-SSSD-DST, and the chrome 4353-SD-DST came with the soap dispenser. Based on your photograph the soap dispenser pictured is not a Delta product.
Date published: 2014-10-24
Black gasket placement on soap dispenser installation
The diagram photo and your previous reply in Q&A state that the black gasket should be installed on top of the sink. How is this possible, there is then a gap (probably 2 mm large, the size of the gasket) between the base of the product and the sink, the dispenser will not sit flush mount, water will definitely get into the gap. The mounting nut is tightly in place underneath, that is not the issue, the design seems majorly flawed. How do you get a flush mount installation to avoid water damage when the black gasket is preventing the unit from sitting flush?
Thank you for your question. The gasket for installing the Delta RP50781 Soap/Lotion dispenser is a thin foam white gasket. This gasket fits on the underside of the trim base, that sits on the sink/counter top.
Date published: 2016-09-24