Cassidy™
Spout Assembly - Bar / Prep
Model#:
RP72681CZ
PRODUCT FEATURES
Special Features
Brilliance® Finish
Brilliance® Finish
Many Delta products are made with Brilliance® finishes, which resist abrasions and discolorations better than traditional brass or even chrome.
SUPPORT
Installation Information
Over All Height :
6-1/2
Connection Type :
NA
REVIEWS
Q&A
The spout assembly for faucet model 9197 comes into the sink 10". How far into the sink does this RP72681 Bar spout assembly reach. I need an 7 1/2 to 8" thrust or reach. What is the thrust on this part?
Hello Rob K,
Thank you for your question! The Cassidy Bar/Prep Faucet (model 9997-DST) has a spout reach of 6 3/8" from the center of the faucet to the center of the aerator. Please refer to the Technical Specifications for this and other measurements.
https://media.deltafaucet.com/SpecSheet/DSP-K-9197-DST%20Rev%20D.pdf
Best regards, Jon
Date published: 2018-08-08
Does this replacement part include the MagnaTite magnet? Or will I need to remove the magnet from the old spout and place it into this new one?
Hi Mike,
Thanks for your question! The MagnaTite magnet will be included with the spout assembly.
Thanks,
Jon
Date published: 2015-06-29
Is the Magnatite magnet available by itself?
Hi, Joe Z!
Thank you for your question. Unfortunately, the spout magnet is not the replaceable part on it's own. You would need to replace the whole spout for the magnet.
Best Regards,
Rosanna
Date published: 2016-11-08
Switch Spout
Just purchased and had plumber install your Delta 19939-SS-DST for a bar / service sink. All assured it would work, but... the spray hits the top edge of the sink. Looking for a smaller spout with less radius to replace existing spout. Beter than replacing the whole unit. Hoping the RP72681 will work. Yes / No?
Thanks, Bob
Hello Bob,
Unfortunately, that particular spout will not fit onto your unit. The only spout we make for the 19939-SS-DST is the one that it comes with.
Best Regards,
Justin
Date published: 2015-09-14