Single Handle Tub and Shower in Chrome

Hello, I apologize for the issue you are experiencing and I am happy to help you. The handle has a set screw which can be removed with a 3/32" Allen wrench. Please see the following links for a parts diagram and How-To video on allowing for more hot water into the mix. https://www.youtube.com/watch?v=L3ty-H1V01I https://media.deltafaucet.com/PartsDiagram/DPD-B-B112920%20Rev%20A.pdf Please reach out with further questions! Best Regards, Tim Digital Communications Specialist

Hello, Thank you for your question! Unfortunately no components for this model are available in the matte black finish. Please reach out with further questions! Best Regards, Tim Digital Communications Specialist

Hello Marv55! Thank you for your question regarding the Delta Faucet Model B114920! I am happy to help. The showerhead is part number RP70536. It has a flow rate of 1.75 GPM. There is not a way to increase the flow. Please reach out to us directly if you need further assistance. Best Regards, Antoine

Hello Melanie, Thank you for your question! We will be happy to help you today! The Delta model B114920 has two set screws for the handle. RP79243 is the smaller of the two and uses a 3/32 inch allen wrench to either tighten to or loosen from the handle. RP74148 is the part number for the Lever Handle with Set Screw, unfortunately, the set screw cannot be ordered separately. I am happy to provide the size of the screw which is #10-24. Either of these screws can be purchased at local hardware stores. Please contact us back for any further questions. Best Regards, Emma

Hello Jay 7264, Thank you for contacting us! I am happy to help you. The B114920 needs to be flushed, The low flow is caused by debris or blockage. I have included the flushing instructions below. 1) Remove the handle by loosening the set screw on the side of the base of the handle. The set screw is either an 1/8" or 3/32" allen screw. So you will need to use the appropriate size allen wrench to loosen it. Loosen it just enough to be able to easily pull the handle off. * Note. If there is calcium build-up at the base of the handle it may be necessary to soak it in a 50/50 solution of vinegar and water. Simply saturate the rag with the 50/50 solution, wrap it around the handle base and place a plastic bag over it. I would recommend do this the night before removing the handle. 2) After removing the handle, remove the trim sleeve. 3) Then you will need to remove the bonnet nut. The bonnet nut is the threaded ring at the valve opening. It unscrews counterclockwise. You will need a pipe wrench or a pair of channel locks. 4) After removing the bonnet nut, you will need to pull the cartridge straight out. You may need a small skinny bladed screwdriver to wedge in between the lip of the cartridge and the valve to help start it out. 5) Once the cartridge is removed, you will have an open valve body. 6) Next, shut the shower door or curtain and turn the water on to the valve. Water should gush out much like an open fire hydrant. Have someone observe if there is good water pressure coming out of the valve and let flush for 30 seconds. 7) Re-install the cartridge and re-assemble in reverse of how it was disassembled. The Tub/Shower should then have a good flow. If it does not, the cartridge will need to be replaced. Please contact us back if you have any questions or need further assistance. We appreciate your business and look forward to continuing to serve you. Best Regards, Nicole

Hello Chuck, Thank you for your question about the Delta Faucet model B114920 Single Handle Tub And Shower In Chrome. I apologize for any difficulty adjusting the temperature. I know that can be frustrating. We are happy to help! As the handle is rotated counterclockwise, the water temperature will increase. The maximum temperature can be adjusted with the rotational limit stop. See the instructions on page 7 of the manual: https://media.deltafaucet.com/MandI/101649%20Rev%20D.pdf Please reach out at customerservice@deltafaucet.com or 1-800-345-DELTA if you have any questions or need additional assistance. Thank you for being a loyal Delta Faucet customer. Best regards, Bryan

Hello Jbob! Thank you for your question and we are happy to help. There is no option for the Delta Single Handle Tub And Shower MODEL#: B114920 in Stainless Steel however a very similar model is B114900C-SS that comes in Stainless Steel. With any further questions or concerns, please do not hesitate to reach out to us directly. Thank you for being a loyal Delta customer. Best Regards, Carrie

Hi Cathie! Thank you for your question and we are happy to help. The tub spout for the Delta B114920 is RP64721 and may be purchased directly from our website. With any further questions or concerns, please do not hesitate to reach out to us again. Best Regards, Carrie