Installation of RP44647 hose assembly
Experiencing the same problem that Greg has stated. The newly designed coupling is too long to make the tight radius curve of the faucet. Turning the faucet holder either to the right or left DOES NOT work.
Can the hose be cut and reassembled with an inserted tube and band clamps? Anything to get this blasted thing to work !!!
Suggestions are appreciated.
Hi Cheryl, Thank you for your question. When you get to the point where the hose is getting hung up try twisting the hose while applying pressure to help guide the hose through the opening.
Date published: 2014-04-03
Is the hose braided and stainless?
Hi CallJoll, Thank you for your question.
The RP44647 hose assembly is a braided vinyl hose. It is not stainless metal.
Date published: 2016-07-14
Which is the correct hose for model 470-wd-dst faucet, RP44647 or RP32527?
Thank you for your inquiry! The Delta RP74608 is the hose assembly listed for the Delta Signature Pull-Out Kitchen 470-WH-DST faucet.
Date published: 2018-01-09
What is the difference with hose RP50390 and RP44647
Hi Eric, Thank you for your question. The RP50390 is the pull out hose assembly for our Diamond Seal Technology (DST) pull out and pull down faucets. The RP44647 is the pull out hose assembly for our non-DST pull out and pull down kitchen faucets. The end that connects to the faucet on each model is different.
Date published: 2014-08-16
Replacement for broken clip?
The clip broke during a repair. Where can I find a replacement clip?
Hi Cherlyn, Thank you for your question!
You will need the RP32522 clip. You can click on the " where to buy" link below for authorized online and local dealers.
Best regards, Brandis
Date published: 2016-02-04
Installing replacement hose RP44647
I received the RP44647 to replace the original hose that was leaking. I was unable to pull the old hose through the faucet after disconnecting it from the valve shank and the spray head without cutting the old hose.
Now I am unable to feed the new hose through the faucet without getting hung up on the two copper intake tubes!
Thank you for your question. We are sorry that you are experiencing difficulties with your faucet. We suggest that you move your spout 90 degrees to the left or right to facilitate threading the new hose through the hub of the faucet.
Date published: 2014-01-23
I am replacing the hose on kitchen faucet MD 474-SS
I can not get the hose to disconnect from the faucet spray head.
I un screwed the nut but it just wont let go. I have tried pulling on it no help.
Is there some kind of release or some type of a "keeper" ring that needs to be released in order for the hose to come out??
Hi Bob, Thank you for your question. Once the threaded portion of the hose is unscrewed there is not anything holding the wand onto the hose on your model 474-SS faucet. It sounds like the o-ring at the end of the hose has dried out and will not slide out easily. Try twisting and turning as you pull to remove the wand.
Date published: 2014-10-06
Which faucets will fit Rp44647?
Thank you for your question, Dkcody26! The RP44647 hose is a non-DST pull-out/pull-down hose. The DST faucets were introduced in 2007 and the easiest way to tell the non-DST vs the DST faucets is by the supply lines. The DST faucets will have gray pex/plastic lines that run out of the faucet to the water shut off valves. The non-DST faucets will generally have copper tubing coming out of the faucet.
Best regards, Edward
Date published: 2018-10-13