Single Handle Bathroom Faucet in Matte Black

Hi Sdd, Thank you for your question. Unfortunately, we do not have a template for the installation hole. We recommend a hole size of 1 1/8" to 1 1/2". Please refer to the Technical Specifications for this and other measurements. https://media.deltafaucet.com/SpecSheet/DSP-L-598LF%20Rev%20F.pdf Best regards, Jon

Thank you for your question, KP. This model can only be installed with the handle on the right. Regarding the ceiling mounted showerhead and trim, I would recommend Delta Faucet model # R10000-UNBXHF rough-in valve with the T17097 valve trim. The raincan showerhead is model # RP72568 and the shower arm and flange is either RP61058(6 inches) or U4999(9 inches). Best regards, Jon

Thank you for your question. Delta Faucet model # RP71545 is not compatible with the 598LF-RBMPU. We recommend that you add a couple of soap dispeners and use one for soap and one for lotion. We recommend Delta Faucet model # RP37039RB.

Hi, LauraMN! Thank you for your question. The Delta 598LF-PNMPU Lavatory faucet can be installed in a sink or counter with a maximum deck thickness of 2 1/8" (54 mm). We do not make a thick deck mounting kit for this faucet. Best Regards, Rosanna

Hi Vrana, Thank you for your question. At high flow the water extends from the end of the spout approximately 5" on the model 598LF-MPU. Thanks, Dave

Thank you for your question, Michael B! The drain assemblies designed for sinks without overflow holes will use different parts than a standard pop up assembly and the flange body can not be substituted for use with the rest of the drain and stopper for your model. An entire Push Pop-Up or Grid Strainer less overflow assembly will be needed and I will include a link to our current selections below. https://www.deltafaucet.com/search-results?searchTerm=less+overflow#resultPage=0&offset=0 Best regards, Edward

Hello Tom, Thank you for your question and I am sorry to hear that you are experiencing low flow from your Delta faucet. We do recommend to flush the valve to make sure no debris is causing the low flow. To flush, first turn off the water supply to the faucet. 1. Remove the handle. On the lever handle, you should find a Phillps head screw under the top cap cover. The handle will lift off when this screw is loose enough. 2. Once the handle has been removed, unscrew the dome-shaped cap. The domed shaped cap will unscrew counter-clockwise. 3. Once the cap has been removed, grasp the round metal stem. The valve cartridge will pull straight out. Also remove the flow restrictor and rinse these parts. You will need to reinstall these parts later, so be sure to note how they are positioned in the valve. 4. Now, with the valve completely disassembled, place a bucket upside down over the top of the empty brass valve body. Turn the hot and cold water supplies back on and let the water run for about 10 to 15 seconds. The water will come directly up out of the valve and should mostly be deflected back into the sink by the bucket. You might have a little bit of water to clean up, though! 5. Shut off the water supplies. Reinstall all parts. If the flow is not better, please contact our Delta Customer Service line at (800)345-3358. We are available Monday-Friday, 7am-7pm, CST and Saturday, 8am-5pm, CST. You may also email at customerservice@deltafaucet.com. Best regards, Tanya

Hello! To remove the handle you will press firmly in towards the faucet, while gripping the handle turn it counterclockwise until it is fully unthreaded. Please reach out with further questions! Best Regards, Tim Digital Communications Specialist