Monitor® 17 Series Tub & Shower Trim in Champagne Bronze

Hello coz123, Thank you for your question. A Multi-choice Universal rough-in valve like the R10000-UNBX/LBX allows you the choice of easily swapping out any of our current shower trim kits. Any current T13/14, T17 or T17T trim will work with this type of rough-in valve. Best regards, Edward

Hi Tim, Thank you for your question. The tub spout that comes with the Lahara collection can only be sweated onto 1/2" C.W.T. or threaded onto 1/2" IPS. Best Regards, Courtney

Thank you for your question, Barbara! Instructions on adjusting the rotational limit stop to decrease or increase the potential maximum temperature on this model can be found on page 7, step 4 of the Maintenance and Installation manual below. https://media.deltafaucet.com/MandI/X00076652_G.pdf Best regards, Edward

Hi Rog, Thank you for your question. The temperature knob cover can be removed by prying up on it from the tip. It should separate from the gray temperature knob, which has a Phillips head screw. Please be sure to turn off the water supplies before disassembling the faucet. Best regards, Jon

Thank you for your question, Dwayne. This trim will work with an existing pre-2006 1700 series valve using the original cartridge (part number RP32104). Best regards, Jon

Hello Frenchyaz, Thank you for your question. Yes, the Delta Lahara Tub and Shower T17438 does come with the RP46463 valve cartridge assembly in its box, fits into our MultiChoice Universal Roughi-In Valve R10000-UNBX. Best regards, Tanya.

Hi Angie, We are sorry that you are experiencing a problem with your faucet. Most likely, you are experiencing "shower-rise" where the water can’t get out of the spout as fast as it flows through the valve. This causes the water to back up and come out the shower head. There can be one of several reasons for this: The valve could be upside down The length from the valve to the tub spout is outside of the 8" to 18" rule There is more than one 90-degree angle Something other than copper or galvanized pipe was used going to the spout The most common reason is that there is something restricting the water flow to the spout, e.g. solder or something lodged in the pipe. Something is impeding the flow of water to the spout and causing it to back up and go out the shower head. If this is the cause of shower-rise it is possible to remove the blockage by removing the tub spout; then, feeding a plumber’s snake or a speedometer cable up through the tub drop. The act of feeding it causes it to twirl and loosen the blockage. Be sure to flush the valve before reinstalling the tub spout. Be sure to check the tub spout itself for blockage. If none of these help, you may need to call a plumber. After the shower has been installed and the wall has been closed, there is little that can be done to remedy this situation yourself. Your faucet is equipped with a rotational limit stop that allows you to set the max hot water temperature on your faucet. Making the adjustment to this piece will raise the water temperature in the faucet. Here is a link to the How to adjust the rotational limit stop video. The 17 series portion of the video starts at 1:50 into the video. http://www.deltafaucet.com/shopping-tools/research/video-gallery/video.html?v=n2_uZ7wgV1I&cat= Thanks, Dave

Hi, George! Thank you for your question. The Delta Monitor T17438-RB Shower Arm measures 5 1/2" in length. We do have longer shower arms and all work with the shower head. For example, our Delta U4993-RB that measures 6" or the Delta RP40593RB that measures 7". We also do have 16" shower arms such as the RP46870RB. Best Regards, Rosanna