Single Handle Pull-Down Bar / Prep Faucet with Touch2O® Technology
Trinsic®
Model#: 9959T-BL-DST
9959T-BL-DST is rated
out of
5 by
46.
Compare
Favorite
Add To A Project
View my Items
Print
Finish: Matte Black
Finish: Matte Black
List Price (US $):
$619.55
-
No-Lead Compliant
- With Touch2O Technology a simple touch anywhere on the spout or handle will start and stop the flow of water
- Helps keep your faucet cleaner, because washing the mess off your hands shouldn't involve making a mess of your faucet
- LED light signals blue when touch mode is active and flash red when batteries are running low
- Automatic water flow shut-off after four minutes helps conserve water
- Integrated TempSense™ LED light shows water temperature, changing from blue to magenta to red as temperature increases
- Battery operated (6 AA included) for up to 2 year battery life or 6 C (not included) for up to 5 year battery life
- Intuitive Touch2O® Technology can sense the difference between a touch and a grab, reducing the chances of false activation
- Optional A/C adapter EP73954 may be ordered separately
- MagnaTite Docking uses a powerful integrated magnet to snap your faucet spray wand precisely into place and hold it there so it stays docked when not in use and doesn't droop over time
- Soft, rubber Touch-Clean spray holes allow you to easily wipe away calcium and lime build-up with the touch of a finger
- DIAMOND Seal Technology is less hassle to install and helps your faucet perform like new for life, reducing leak points and lasting twice as long as the industry standard
- Everything you need is together in one convenient box, including integrated InnoFlex® PEX supply lines
- 1 or 3-hole 8" installation
- ADA Compliant
- High-arc pull-down swivels 360degrees
Technology
-
Electronic Faucet
-
Touch2O Technology®
-
MagnaTite® Docking
-
DIAMOND™ Seal Technology
Special Features
-
ADA Compliant
Installation Information
1 or 3-hole 6" or 8" installation
- Escutcheon: Optional Escutcheon Available
- Flow Rate: 1.80 gpm @ 60 psi, 6.8 L/min @ 414 kPa
- Spout Height: 13"
- Spout Length: 6-1/2"
- Deck to Outlet: 7"
- Fittings Type: 3/8" compression fittings
- Deck Thickness: 2.25"
- Supply Lines: Included InnoFlex® Pex-C Supply Lines
- Valve Type: Electronic with Euromotion DIAMOND™ Valve
Rated 2 out of
5
by
Dayle from
Don’t waste your money.
My new house came with this faucet. It worked about 80% of the time for the first few months. Then it got worse. Sometimes the water would stop without any touch at all. Sometimes I would touch and then touch again to try to make it work or stop. Finally I got my husband to pull off the touch feature and it now works like a regular faucet should.
Date published: 2018-08-12
Rated 5 out of
5
by
Bob from Fairhope from
Love That it Matches The Sink Faucet!
We bought both the kitchen sink version as well as the smaller bar sink version for our island prep sink. They look great together and work perfectly. The only design suggestion I would make is to scale down the diameter of the bar sink model to be more in proportion to its size. It looks a bit 'pudgy' for its height.
Date published: 2018-06-05
Rated 5 out of
5
by
Dallas from
Delta Kitchen Faucet
Put this in my newly remodeled kitchen. Love it!! Very classy! Love the touch sensor too!!
Date published: 2018-04-20
Rated 5 out of
5
by
Cathie from
Worth the splurge
Install ours last summer and love it. Only issue is water marks. More visible on the Champagne Bronze finish. Called company & they suggested solution of water and vinegar in spray bottle. Works.
Date published: 2018-03-02
Rated 3 out of
5
by
Green Frokie from
It us a great faucet... Until it stops working
I've had this faucet for almost 2 years now...Changed the batteries 2x so far. But after yesterday change, the touch featured stopped working...Plug unplug repeat... No dice. A faucet costing the that much should come with problems., Especially when one buys this faucet for its touch feature.
Date published: 2018-02-26
Rated 5 out of
5
by
Ed from
Great!
I am a contractor, and I installed this for my customer once, and I liked a lot, so I bought for my house, and my wife loves it, it works well, looks simple and nice, it’s been 6 months now, no single problem
Date published: 2018-01-20
Time to replace our existing Delta faucet (had it for 25 years!) - which has a 12” high arc. I am worried that the Trinsic 15.5” kitchen faucet will be too big. I have an Elkay double sink that is only 9” deep on main side and only 7” on the smaller.
Hi, Katie!
Thank you for your question. The Delta 9959T-DST Bar/Prep faucet is slightly smaller than the full-size kitchen faucet, 9159T-DST. The 9959T-DST Bar/Prep faucet is 13" and the full-size kitchen faucet, 9159T-DST, is 15 11/16". Here is a link to the technical specifications sheet that will show the measurements for both units:
https://media.deltafaucet.com/SpecSheet/DSP-K-9159T-DST%20Rev%20E.pdf
Best Regards,
Rosanna
Date published: 2018-07-12
My faucet water flow has slowed to a trickle. How do I fix this?
Hi, Anna!
Thank you for your question and I am sorry to hear that you are experiencing low flow from your Delta faucet. We recommend to flush the lines and clean the debris screen at your solenoid assembly under the sink. To flush the lines, make sure your handle is in the 'off' position. Disconnect the top hose from your solenoid assembly and point it into a bucket. Turn on the water from your handle and let the water flow through the open hose into the bucket. Does it have adequate flow? Since the hose is disconnected, this is a good time to take the debris screen out of the solenoid. The debris screen is located in the opening of the solenoid where the hose was connected into. Take a pair of needle nose pliers and pull the small debris screen out. Clean the debris screen by rinsing it in running water at another faucet in your home since your kitchen faucet will be disconnected. Install it back into the solenoid and connect everything back up. Turn the handle in the off position. Disconnect the hose from the bottom of the solenoid. Point the whole solenoid into the bucket. Turn the handle in the 'on' position. Flush the solenoid through.
If this does not fix the flow issue, please contact our Delta Customer Service line at (800)345-3358. We are available Monday-Friday, 7am-7pm, CST and Saturday, 8am-5pm, CST. You may also email at customerservice@deltafaucet.com.
Best Regards,
Rosanna
Date published: 2018-06-21
Model #9959T is leaking above the sink at the spout assembly (rp71655)meets the the retainer(rp60923). What is the repair?
Hi, Dave!
Thank you for your question, and I am sorry to hear that you are experiencing an issue with your Delta faucet. If the faucet is leaking at the spout retainer, we would recommend to replace the hose assembly, since the water travels through the hose assembly, itself. The hose assembly part number is RP80522. Here is a link to the part:
https://www.deltafaucet.com/parts-product-detail?modelNumber=RP80522
Best Regards,
Rosanna
Date published: 2018-05-31
What does a flashing red light mean?
Thank you for your question, Jillsy! Normally, if a Delta touch faucet has a flashing red light, it means the batteries need to be changed. If batteries are not changed it can cause the solenoid to shut does and no water will run out of the faucet, until the batteries are replaced.
Best regards,
Tanya
Date published: 2018-01-16
How far does the hose reach on the bar faucet?
Hi Eva,
Thank you for your question. The Delta Trinsic Touch2O Technology Pull-Down kitchen 9959T-CZ-DST faucet comes with a 62" hose assembly and it will pull out 22" from the end of the spout.
Best regards,
Tanya
Date published: 2018-01-03
Does the handle move back as well as forward?
My backsplash is a little less that 3 inches from the center of the hole.
Thank you for your question, Susan! The handle will only move forward from the upright position. We recommend having 2 1/2" or more between the backsplash and the center of the mounting hole.
Best regards,
Jon
Date published: 2017-01-24
Can the handle be switched to the left side?
Hi JC,
Thank you for your question. The faucet is only designed for the handle to be installed on the right side due to the rotation of the handle and the position of the light at the base.
Best regards,
Jon
Date published: 2016-11-23
What does a red light on mean?
A red light keeps coming on instead of the blue light? What does this mean?
Hi AJK,
Thank you for your question! For models manufactured prior to 2015, a solid red light means that the batteries will need to be replaced. Solenoids manufactured after January 2015 will cause the light to flash red when the faucet is turned on or off if the batteries need to be replaced.
Best regards,
Jon
Date published: 2016-09-21
