How do you change the diverted valve for T4759?
Tube filler is a little older than 1year. Water is leaking from the wand. I need to change the diverted valve. How do you remove the wand holder assembly (RP74808)?
Thank you for your question and I am sorry to hear that you are experiencing a leak from your diverter for your roman tub filler faucet. The holder assembly can be removed by unscrewing the holder part counter clockwise. Here is a link to the RP74808 so that you can see a close up of the threaded part.
Date published: 2018-01-17
Can you slow the flow rate down?
I have this model and I have a tankless water heater. During the winter I need to slow the flow rate down to get hotter water at times. The handle does not adjust flow rate, only temperature. Is there something that could be installed to decrease the flow rate to the faucet?
Thank you for your question. The cartridge in the T4759-RBFL floor mounted tub filler has a rotational limit stop that controls how hot the water can get. This may need adjusted. If this is already set to the hottest position, then you may need to contact the manufacturer of the tankless water heater to find the ideal setting to accommodate the flow rate of this model.
Date published: 2018-01-14
Which rough-in valve is suggested for installation on/in concrete slabs? Neither installation manual shows a slab type installation.
Can this valve be installed in or under the concrete slab
Date published: 2018-01-11
Hot is Cold
We have this floor mounted faucet but when
we turn it on it comes out hot first and if we keep
turning it goes to cold. Is it possible that it is
mounted 180 degrees out? Can we just lift
It up and rotate it? It is mounted on the left
side of the tub. I heard somewhere that it should
Be mounted on the right side of the tub but
That would reduce the design possibilities.
Thank you for your inquiry, Schuffy! We would advise removing and rotating the valve cartridge assembly 180 degrees and reinstalling it. This should allow the cold water to run first, out of your Delta Contemporary Floor Mount Roman Tub T4759-FL model.
Date published: 2017-12-07
Is the height adjustable, and if so, what is the range?
Thank you for your question. The total spout height is 41" and the end of the spout is 37" above the floor. The height is not adjustable.
Date published: 2017-10-20
Are there shorter main tubes for this unit?
This is the standard 31mm tube and it is too tall for our tub, causing lots of splashing in and out of the tub.
Hi, BJ & Jean!
Thank you for your question. Unfortunately, we do not have a shorter main tube for this tub filler.
Date published: 2017-07-20
I need an overflow drain assembly for my freestanding tub, is there anything in champagne bronze that matches my tub filler?
The tub came with no overflow drain, plumber is drilling into tub to create one per WI building code.
Thank you for your question! Delta does not manufacture drain assemblies for roman/whirlpool/garden tubs. If you have a standard tub we do make the Delta Bath Waste Assembly RP693CZ, that would match the finish of the Delta Trinsic Floor Mount Tub Filler Trim Kit T4759-CZFL.
Date published: 2017-06-26
hose outlet connector size?
What is the size of the outlet where the Handshower Hose connects?
Thank you for your question. The hand shower hose connection is 1/2".
Date published: 2017-05-19