Single Handle Pull-Down Kitchen Faucet in Chrome

Once the 54" hose that it comes with is installed, how much of that hose can be extended from the faucet? If I substitute it with the 62" hose, are you saying that it will only extend 18-22" from the faucet? I am looking for a faucet that has approx. 24" extension to reach cooktop next to sink. Thank you.

Hi, Studio Outside! Thank you for your question. Unfortunately none of our kitchen sink faucets are specifically designed to be installed outdoors. They are not designed to withstand extreme cold weather conditions (freezing) or direct sunlight from the sun in the summer months. If you do decide to install one of our faucets outdoors, then please remember that our warranty only covers manufactures defects. Damage incurred to the faucet by the extreme weather conditions are not covered by our warranty program. Best Regards, Rosanna

Hi, Mark! Thank you for your question. You will want to make sure to move the handle away from the faucet to turn on the water. When the handle is out, the water should be all cold. When you move the handle closer to you, the water should get warmer until the handle is towards you, it should be at the hottest position. Best Regards, Rosanna

Dear Marion, Thank you for your question. I have registered your Delta faucet 19933-SD-DST model for you. Also, we ask that you hold onto the warranty/installation paperwork, that came with the faucet and a copy of your original receipt or proof of purchase for any warranty claims in the future. Best regards, Tanya

Hi, Dena! Thank you for your question. The Delta 9159-DST faucet is a full-size kitchen faucet while the Bar/Prep faucet is a smaller version of the 9159-DST faucet. Here is a link to the technical specifications sheet to show the different measurements: https://media.deltafaucet.com/SpecSheet/DSP-K-9159-DST%20Rev%20E.pdf Best Regards, Rosanna

Water flow can be very strong, in fact it is hard not to spend so much water. It is not normal to open gently, meaning first you pull out lots of water come out. It doesn't pull out that far to be a problem. I would not recommend the ergonomics of this faucet, I have it and I am stuck with it.

Hi, Steve! Thank you for your question. The Delta 9159-DST Faucet does not have a removable aerator assembly in the sprayer. We do apologize for any inconvenience this may cause. Best Regards, Rosanna

Hello DMeng, Thank you for your question. The three Delta Kitchen Pull-Out/Down faucets with a 1.5 GPM at 60 PSI are models 9192-DST, 4153-DST and 4353-DST. https://media.deltafaucet.com/SpecSheet/DSP-K-19992-SD-DST%20Rev%20B.pdf https://media.deltafaucet.com/SpecSheet/DSP-K-4153-DST%20Rev%20C.pdf https://media.deltafaucet.com/SpecSheet/DSP-K-4353-SD-DST%20Rev%20B.pdf Best regards, Tanya

Hi, Brendan! Thank you for your question. The diameter of the spout on the model 9159-DST is 1-3/8". Best Regards, Rosanna

Hi JD2020, Thank you for your question! The Delta Trinsic Pull-Down Kitchen 9159-DST faucet requires a 2 1/2" (64 mm) maximum deck thickness with the 10 1/2"escutcheon plate or a 3" (76 mm) maximum deck thickness without the 10 1/2" escutcheon plate. Please feel free to call, email, or message us on social if there is anything you need. https://media.deltafaucet.com/SpecSheet/DSP-K-9159-DST%20Rev%20F.pdf Best regards, Tanya Phone: 1-800-345-3358 | Email: customerservice@deltafaucet.com | Facebook/Twitter: @deltafaucet

Thank you for your question, tania4444! I do apologize that you are not getting any water flow to your touch faucet, but will be more than happy to help! Model 9159T-DST runs on batteries, as a default option. When those batteries die, the light at the base of the faucet will blink red 3 times. Once the batteries die, the faucet will not be able to get water until new batteries are installed. Feel free to contact us directly, if you need further assistance. Best Regards, Benjamin

Hi, Susan! Thank you for your question. The Delta 9159-DST faucet handle can be tightened by first removing the red/blue temperature indicator. The set screw can be retightened with a 1/8" allen wrench. Best Regards, Rosanna

No. I cannot understand why Delta approved this type of aeration in the first place. I constantly splash when trying to rince certain items and it is getting really annoying.

Hi, Colin! Thank you for your question. Here is a link for the warranty for our Delta faucets: https://www.deltafaucet.com/service-parts/warranty If you are experiencing an issue with your Delta faucet, please contact our Delta customer Service line at (800)345-3358. We are available Monday-Friday, 7am-7pm CST and Saturday, 8am-5pm, CST. Best Regards, Rosanna

Hello Ernie, Thank you for your question! The Delta Trinsic Pull-Down Kitchen 9159-DST faucet can be installed as a single hole installation and a soap dispenser added for the second hole of the install. Please feel free to call, email, or message us on social if there is anything else you need. Best regards, Tanya Phone: 1-800-345-3358 | Email: customerservice@deltafaucet.com | Facebook/Twitter: @deltafaucet

Hi, DPaul! Thank you for your question. The escutcheon plate is .45" thick. The 9159-DST faucet with the escutcheon plate is 15 11/16" and without the escutcheon plate it is 15 1/4". Best Regards, Rosanna

Thank you for your question, mzack! The recommended clearance to the back splash is 1 1/2" (38mm) is measured from the center of the faucet or handle. https://media.deltafaucet.com/SpecSheet/DSP-K-9159-DST%20Rev%20E.pdf Best regards, Edward

Hi, craig1961! Thank you for your question, and I am sorry to hear that you are experiencing low flow from your Delta faucet. Over time, common water debris will settle in the house supply lines. Anytime the water is shut off to a portion of the home, this debris can become dislodged and will move through the pipes to be caught by a faucet. Local construction or the changing of the seasons can also cause this. Flushing the supply lines through the unit should remedy this situation. To flush the unit, we recommend the following: Start with the easy stuff: Remove your aerator, wand or hose to check the flow through the unit without that part installed. If the flow is good, the piece you’ve removed is where the issue is. Soaking the part in a 50/50 mixture of white vinegar and water could help remove any particles or debris blocking the flow. If the water does not have a good flow, the problem could be in the faucet. Next, check the supply lines for debris: Turn the supply off to both the hot and cold-water lines. Once off, turn the handle on the faucet to the on position and leave it there to bleed the lines of any excess water. Next, disconnect the hot water supply line and place it inside of a bucket. Once the line is securely positioned into the bucket, turn on the cold-water supply. Since the handle was left in the on position, the water will flow up the cold supply line, through the faucet cartridge and back down the hot water line into the bucket. Leave this flowing for at least 30 seconds. After flushing, reconnect the hot water line and repeat this process with the cold-water line to ensure all particles have been removed from both supplies. If this does not fix the issue, please contact us back. Best Regards, Rosanna

Hi Estana, Thank you for your question! The spout is 1 1/4" in diameter. Best regards, Jon

Hi, Laurie123! Thank you for your question. Please know that all of our products undergo rigorous tests to ensure long-lasting use and are made with high-grade materials. If you have any questions or need help, please feel free to contact our customer service department at 1-800-345-3358 or email us at customerservice@deltafaucet.com. Best Regards, Rosanna

Hi, Thank you for contacting us. We apologize for any inconvenience with your Delta Faucet Company product. I am also more than happy to have this opportunity to help you. I see that you have already been assisted with this issue. If you need help with the installation of your order, please feel free to contact us back, as we would be happy to help. You can reach our customer service team at 1 800 345 3358, Monday through Friday from 7 am to 7 pm and Saturday 8 am to 5 pm CST. Best Regards, Bethany

Thank you for your question, Julie64! The handle on the model 9159T-DST faucet is held on by a set screw which is located underneath the button opposite the handle lever. You will need to pry off this button to access the screw that uses a 1/8" allen wrench to tighten the screw onto the cartridge. Best regards, Edward

Thank you for your inquiry, TomL! The Delta Trinsic Pull-Down Kitchen 9159-DST faucet model is not designed with the ShieldSpray Technology. Best regards, Tanya

Hi, Joie! Thank you for your question. The Trinsic Single Handle Pull-Down Kitchen Faucet (9159-DST) spout assembly does swing 360 degrees. Best Regards, Rosanna

Hello, Tim W! Thank you for your question. The 9159-DST has a removable spout assembly. To remove the spout, first push in the small button at the back of the spout assembly. At the same time the small button is pushed in, twist and pull the spout assembly up and off of the base of the faucet. Best Regards, Rosanna

Hi, Aaron! Thank you for your question. We do not have Delta Trinsic faucet that does not have pull down sprayer assembly. We also do not have sprayer assemblies that have just the stream mode option. Best Regards, Rosanna

Hi, Akko! Thank you for your question. We do not recommend to install a water filter to the Delta 9159-AR-DST Faucet sprayer assembly, as potential pressure fluctuations during water filter operation may result in the hose rupturing. Best Regards, Rosanna

Hi, wbcIII! Thank you for your question. The Delta 9159-BL-DST faucet may not be shipped to Brooklyn, NY 11237 as it has a flow rate of 1.80 GPM @ 60 PSI. The maximum flow rate to be within the NYC Green Code is 1.5 GPM @ 60PSI. Best Regards, Rosanna

Hi there Becca, Thank you for your inquiry! A comprehensive list of cleaners is impossible to recommend because of the variety of materials that are a part of our many models of faucets. What may be fine for a spout may damage a handle. To clean, simply wipe gently with a damp cloth and blot dry with a soft towel. Stubborn hard water spots are best avoided by this daily regime. If extra measure is needed, a solution of 50% white vinegar (never Apple vinegar) could be used by wiping, spraying or soaking. Caution: Vinegar can permanently damage porous rock surfaces such as granite or limestone countertops. Use extreme care if such a surface is in the vicinity. To soak a faucet or part still on a faucet: 1. Mix white vinegar and tap water to a half and half proportion. 2. Put a rag or towel in the solution to soak it up. 3. Wrap the rag or towel around the part. 4. Let sit for up to an hour or so. 5. Use the rag or a clean, soft toothbrush to scrub the remaining hard water buildup. o Avoid harsh abrasives or polish o Avoid bleach-based cleaners o Avoid industrial cleaners and abrasive cleaners, such as those used for toilet bowls, green Scotch-Brite heavy duty scrub sponges, Scrubbing Bubbles Bathroom Cleaner and Lysol Basin Tub, Soft Scrub, and Tile Cleaner. o Avoid products that state on the label that they remove tarnish and rust, and those containing hydrofluoric, hydrochloric and/or phosphoric acids and caustic agents. o Because cleaning formulas can change without notice, Delta Faucet Company does not endorse any specific cleaner. Best regards, Tanya

Hi Gary, Thank you for your question. The model 9159-AR-DST does have an aerator that is part of the wand assembly that controls the flow of water when the faucet is in stream mode. Thanks, Dave